Description

Why we need it? We are always confused that the suction cup is not strong enough and falls off，Now we have found a good solution, Try our super adhesive for lock sucker. Feature: 1.Compatible with most suction cup dashboard mount and other windshield long arm mount, GPS holder, EZ Pass, I-Pass, SunPass holder, camera mount, ETC, wireless charger base, dash camera mount holder etc on the market. 2.You can cut clear sticky adhesive into smaller pieces if need. Easy to install Step1: Remove the used adhesive and then clean the surface with provided alcohol pad until dry. Step2: Peel off the white film, stick it on the PVC plate. Step3:Press for more than 12 seconds to make it better adhere to the selected area Step4:Wait 24 hour and then press the suction cup mount on it. Easy to remove Step1:Use something like floss to cut old adhesive at a slow rate. Step2: Remove used adhesive by hand. Step3:Use prvided alcohol pad or wet cloth to clean the surface Note: 1. Adhesive can only be used once. 2. Please wait 24 HOURS to use after stuck on the surface. 3. Choose the relatively flat surface of your dashboard. 4. Be not used in silicone pads. 5. If you want to adhere the transparent adhesive to the surface of the suction cup directly, please put down the air valve first. Package Includes: 6 pack 80mm (3.15") sticky adhesive replacements 6 pack Alcohol Prep Pads 【6Pcs Clear Adhesives Replacement】AZXYI offers 6 Pcs round clear sticky adhesive pads(Diameter: 80mm,3.15") for attaching dashboard pad mounting disk of your suction cup dashboard phone mount. You can also adhere the transparent adhesive to the suction cup directly, not affecting the look of the suction cup. 【Easy to Use】To maximize adhesive contact, please clean the adhesive surface before use and let it dry, free of contaminates. And wait at least 24 hours to use after stuck. First peel off the white side of the adhesive and stick it to the car mount base. After applying some pressure on the adhesive, peel off the red film side of the adhesive and stick the car mount to your dashboard/ windshield. 【Cut into any size you need & Compatible With Suction Base】You can cut pads into smaller pieces if need. Compatible with most suction cup dashboard mount and other windshield long arm mount, GPS holder, EZ Pass/I-Pass/SunPass holder, camera mount, ETC, wireless charger base, dash camera mount holder etc on the market. 【Easy to Install】Provided rounded rectangle raised label to easily peel off the red release film of the adhesive pads. When using, first easily peel off the white release film, stick the adhesive to the dashboard pad mounting disk or to the suction cup base directly, then peel off the other red side film and stick to your car dashboard. Press down repeatedly to increase the contact of the adhesive with the substrate. please wait 24 HOURS to use. 【Very High Bond & Easy to Remove】These high-strength, double-sided adhesive pads let you quickly and easily create a long-lasting bond, bonding almost instantly with no drying time. It also resists heat and moisture, and protects adhesive surfaces against scratches, easy peels off without leaving any sticky residue behind.